Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bystronic Bysprin 3015 excitation problem 1

Status
Not open for further replies.
StevenLatt

StevenLatt

Mechanical
Apr 10, 2018
15
Hello,
I have problem with bysprint 3015 4400w laser. There is a excitation module 1 error. I try to reset that error after that i can cut 2 details and then excitation errors are back.
20181018_104404_f4f9fd.jpg

20181018_104412_jdtknq.jpg

20181018_104327_p9ixfw.jpg
 
Replies continue below

Recommended for you

Sort by date Sort by votes
believe it or not there were issues with the cooling fans locking up inside these which would shut the module down and cause all kinds of weird errors. Fan is behind front panel, you can jump the signal wire coming out of the fan to bypass it and test it. i can't remember if it has to be connected to vcc or ov to bypass, doesn't hurt to try either. don't electrocute yourself. most other excitation module issues are problems with laser gas/leaks.

Chris Krug Maximum Up-time, Minimum BS
 
Upvote 0 Downvote
Yes. bystronic send me same instructions friday. It helps. Module 1 fan is not working. I connected wire to bypass. its right. Thank you Krugtech for help!
 
Upvote 0 Downvote
We had the same issue here. Just replaced the fan and good as new.

This is one of the many errors you get in regards to leaks.

E_133_error_l7xhwn.gif


If you ask me to do something, I will do it. There's no need to nag me every 6 months
 
Upvote 0 Downvote
Yesterday arrived new fan. Not the original part but analog Embpast fan. There is the data of this fan: When turbine blower and operating pressure is reached starts excitation modules only 10 seconds. Then they go off and i have same errors back.
I changed module 1 and module 2 fans and now i have error in module 2. before changing in module 1. For sure something with new fan. Maybe it not fit here.
 
Upvote 0 Downvote
that should work. By the way, the official replacement fan bypasses the rpm signal so failure will not stop the module. With the water cooling it might not need the fan anyway.

Chris Krug Maximum Up-time, Minimum BS
 
Upvote 0 Downvote
New fan is arrived and it works. One bystronic service guy said same what you. But yes, problem is fixed and thanks for help!
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Darren Bendall
  • Locked
  • Question
Bystronic Bystar 3015 4.4kw 1
Replies
10
Views
1K
krugtech
krugtech
Upadam
  • Locked
  • Question
bystronic 3015
Replies
1
Views
290
krugtech
krugtech
pupdogg
  • Locked
  • Question
Bystronic BySpeed 3015 Y-Axis Binding/Stuttering
Replies
0
Views
605
pupdogg
pupdogg
navnet
  • Locked
  • Question
Bystronic Byspeed 3015: error E29
Replies
2
Views
609
navnet
navnet
Darren Bendall
  • Locked
  • Question
HI We have a bystronic bystar 3015
Replies
2
Views
676
Darren Bendall
Darren Bendall

Part and Inventory Search

Sponsor

Back
Top Bottom