Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

C1541 vs. Grade 5 1

Status
Not open for further replies.
5iron

5iron

Agricultural
Dec 28, 2011
1
0
0
US
Shopping for 3/4 - 16 UNF plain threaded rod. Engineering dwg calls for SAE Grade 5. One attractive bid specifies C1541 material. Is this acceptable?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
5iron - Yes. C1541 material meets the chemical requirments of SAE J429 Grade 5. You will want to ensure it is heat treated properly to meet the Grade 5 requirements.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Rreach
  • Question
GE Frame 5 Rotor high 1x vibration
Replies
3
Views
39
Rreach
Rreach
rollingcloud
  • Question
installation vs seating torque
Replies
9
Views
49
CWB1
CWB1
Myint Mo
  • Locked
  • Question
Fit grade for plastic container
Replies
2
Views
21
btrueblood
btrueblood
liamlucas
  • Locked
  • Question
offshore installation vs onshore installation
Replies
14
Views
33
dgeesaman
dgeesaman
edleit
  • Question
NPT vs NPSM thread for conduit nut
Replies
2
Views
36
Compositepro
Compositepro
Back
Top