CAITA SCREEN LOCKED

[merium]

Hello all,

I have faced an issue on Catia V5, when I was trying to fix this problem showed below
I suddently cannot remove the error message even clicking on "OK" servals times, the screen remain blocked,
Is there a solution to this problem ?

 

[jackk]

Could you please inform us as to which workbench you're using and which feature you're trying to fix. A screen shot of the entire pop-up window would be very helpful for us to help solve you're problem.

The error message suggests too big of a diameter with too small of a bend radius. Can you modify the center curve to remove sharp bends?

 

[merium]

Hi jack
im working on EHI/EHA harness Routine, the real problem is that the message sign wont disappear although clicking on OK several times, and im afraid that if I force catia to be closed and restart it , the project wont be saved.
thanks in advance

 

[jackk]

(oh, Wire Harness. I thought it might be Tubing)

try ESC to back out the error. Or CANCEL

 

[Little Cthulhu]

There's a checkbox "Do not show this dialog next time", have you tried it?

 

[merium]

hello guys,

no ESC or Cancel was working, I have forced the application to be closed and I lost all work,
cause when I tried to open the project in hope to recover the session, catia opened without that message for recovering

thank you