Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

CAM grip programming

Status
Not open for further replies.

terman

Mechanical
Joined
Mar 29, 2005
Messages
4
Location
FR
I'm using NX2

i've created a table for feeds and sppeds and it's working quite ok.

but i've to go into each operation and click to calculate feeds and speeds.

is there a way to automate this using grip. What i would like is a single click and it will go and set the feeds and sppeds in all the operations.

Thanks for your help
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top