CAM: Re-enable warning message 3

[JeroenD]

Hi,

I recently had a warning message "Motion to Start of Engage" in CAM.
I accidently checked "Don't display this message again" before clicking on OK and now (as expected) the message doesn't show anymore.

I want to re-enable that message but I can't find it.
I presume it's located somewhere within the customer defaults.

If you know something more, please let me know.

Thanks in advance,
Jeroen

 

[Arkance/PhoeNX]

I don't believe it's in the Customer Defaults.
I believe it's in Registry key -> HKEY_CURRENT_USER\Software\UNIGRAPHICS SOLUTIONS\NX\9.0\Hide_message
See image below for the hidden warning from my system.
I think if you look at yours you'll find what you're after.

Anthony Galante
Senior Support Engineer


NX3 to NX10 with almost every MR (21versions)

 

[joycejo]

On the user interface preferences is an option Reset "Don't display this message again"



John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX7.5, NX9.0, NX10.0(Testing)
Vericut7.3.3

 

[JeroenD]

Thank you both for your response.

I've tried the interface preferences option (registery editor seemed a bit more complicated) and it worked.
Thanks!

 

[Arkance/PhoeNX]

Why do I always look for the complicated answer?

Anthony Galante
Senior Support Engineer


NX3 to NX10 with almost every MR (21versions)

 

[cowski]

Because it's your job.

www.nxjournaling.com