Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Can a Drafting View be cut in half for Sym

Status
Not open for further replies.
mark528

mark528

Mechanical
Dec 10, 2004
34
Is it possible to cut a view in half to save space on the sheet if it is symetrical? currently we are having to break the view on one side to hide as much of the geometry as possible. Any help would be greatly appreciated.

Mark
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

JHCMMAN
  • Locked
  • Question
Cannot create Front View in Drafting
Replies
0
Views
100
JHCMMAN
JHCMMAN
thallwright893
  • Locked
  • Question
Catia Drafting: Add section cut callout to views created using 'View from 3D'
Replies
0
Views
91
thallwright893
thallwright893
Rich68
  • Locked
  • Question
2d Catalog Components orientation in drawing view
Replies
3
Views
99
Little Cthulhu
Little Cthulhu
flatpane1
  • Locked
  • Question
CATIA V5 Drafting view scaling without affecting annotations.
Replies
5
Views
88
Little Cthulhu
Little Cthulhu
M. Balola
  • Locked
  • Question
How can I handle different weld symbols for a dedicated standard in Catia V5 R19 drafting?
Replies
0
Views
78
M. Balola
M. Balola

Part and Inventory Search

Sponsor

Back
Top Bottom