Can anyone help me I have just purc

[Balticpete]

Can anyone help me I have just purchased a 1988 fanuc tape cut wire edm and it has no cutting condition tables I am using .25mm dia wire
I will be cutting copper,tool steel (various grades),high quality carbon steel (en24 ect),brass,aluminium
I have used the same controll for years on my hitachi Q cut but the generator is a different type and the cutting conditions I have for that won't work at all

Any help would be much apreceated thanks in advance

 

[MiketheEngineer]

Call the vendor??

 

[Balticpete]

These are really old machiens and getting information out of fanuc is not only really expensive but very very time consuming I have posted on here and a coupe of other forums to see if anyone has a manual of the cutting conditions as a couple of emailed pages would get me started
It's like trying to bake a cake without a recipe