CAN Termination resistor

[jbc57]

Hello all,

I'm looking for a standard automotive CAN Bus termination resistor to implement in a wire harness. I know that a 120 Ohms resistor is needed at each end of the bus to isolate it from noise. I have 3 nodes on the bus and only one is terminated. Since this goes for several units, welding a standard resistor between the 2 cables is not acceptable.
Therefore, if you have any clue on connectors featuring such termination or anything else, it would be really appreciated.

Best regards,
JB

 

[jbthiel]

On my last project we "created" a standard termination resistor using a deutsch DTM connector, a resistor connected to two pins, and a bit of shrink tubing. Crude, but it worked well.