Can the TAG ID be edited in a hole table? 2

[Aubreyair]

Is there a way to edit a TAG ID in a hole table?
As an example I selected 4 features and they were labeled under TAG as A1,A2,A3,A4 in the chart and on the drawing.
I would like to change the id to E44,E45,E46,E47 is this possible?

 

[J-C]

Nope, you'll have to submit an enhancement request for this functionality.

Jason

UG NX2.02.2 on Win2000 SP3
SolidWorks 2005 SP5.0 on WinXP SP2
SolidWorks 2006 SP1.0 on WinXP SP2

 

[wmdn]

I submitted an SPR for this earlier this week. You should submit one as well. Maybe if there are enough requests SW will implement the enhancement.

 

[Aubreyair]

As mentioned previously I am new to SolidWorks.
Here is my question do I have to go to SolidWorks website to submit an SPR?
Or can I do that through this forum?

 

[J-C]

SPR is a bug report, you go through your VAR for that.

The enhancement request form is in the subscription area of the Solidworks website.

Jason

UG NX2.02.2 on Win2000 SP3
SolidWorks 2005 SP5.0 on WinXP SP2
SolidWorks 2006 SP1.0 on WinXP SP2

 

[CorBlimeyLimey]

You cannot do that through this forum. Although this forum is all about SW, it is not operated or sponsored by them.

You should submit an ER via the SW website. Informing your VAR would not hurt either.


Helpful SW websites every user should be aware of faq559-520
How to get answers to your SW questions faq559-1091

 

[wmdn]

You are, of course, correct. It is an enhancement request, not an SPR. ER is what I submitted. Sorry if I misled you.