Can this be made in the sheet metal package?

[FXjohn]

I have NX 7.5 NX sheet metal application. take a look at this picture

 

[JohnRBaker]

That's not exactly the type of 'sheet metal' part that the NX Sheet Metal module was designed to address. However, if you're going to be making a crap-load of these things, you may want to look at our Progressive Die Design module:

http://www.plm.automation.siemens.c...g-fixture-design/progressive-die-design.shtml

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[FXjohn]

For the most part I'd be satisfied with a flat pattern, even if it was just wirefrane. the system doesn't seem to be able to unfold dents or the wall corners.
I will look into the progressive die module