Not really sure where to put this. Been using Draftsight for a while. I updated from 16 to 17 and something strange has happened, I can't delete entities by highlighting and pressing Delete. All that happens is the highlight goes away but the lines are still there. Any ideas?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Can't delete entities 1
- Thread starter n_spect_r
- Start date
-
1
- #2
Found this response from John Connor to similar question:
I'd try either PICKFIRST or PICKADD or whatever the AutoCAD equivalent command is in DraftSight.
I think these are the equivalent commands in DraftSight:
ENBLENTSELPRESEL
SETENTSELADD
Set each to a value of "1".
I'd try either PICKFIRST or PICKADD or whatever the AutoCAD equivalent command is in DraftSight.
I think these are the equivalent commands in DraftSight:
ENBLENTSELPRESEL
SETENTSELADD
Set each to a value of "1".
- Status
Similar threads
- Locked
- Question
- Locked
- Question