Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Can't display nodal solution of Tutorial

Thread starter ZegersSander
Start date Oct 27, 2004

Status: Not open for further replies.

Oct 27, 2004

ZegersSander

Civil/Environmental

Hi,

I started with Ansys recently and did the structural tutorial. I followed it to the letter, but I can't get the nodal stresses to be plotted.

When I open General Postprocessing->Plot Results-> Contour plots-> Nodal Solu the list that appears only list Nodal -> Contact

Any ideas where it went wrong?