I previously posted this question in the wrong forum. I would like anybodys opinion on cutting stainless seamless tubing with either of these saws. They both seem capable, but with advancements in materials and cut profiles, its hard to tell which is better. I would definately be looking at low rpm, high torque, to reduce the amount of heat going into the material. Any thoughts/feedback would be appreciated.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Carbide Tipped saws vs HSS?
- Thread starter limey1
- Start date
- Status
Similar threads
- Locked
- Question