mombu
Mechanical
- May 16, 2009
- 7
Dear all,
has anybody already experienced the calculation and use of this kind of gaskets ?
I am facing the calculation of carrier ring gasket with OMEGA RING in two(2) halves with two cases "on the table":
CASE 1) two 2 halves of OMEGA metal gasket each holding a spiral wound gasket which are in contact with the flange face.
CASE 2) two 2 halves of OMEGA metal gasket each holding a spiral wound gasket which are in contact with the flange face + an additional spiral wound gasket in the middle and between the two halves.
- How can I perform the calculation?
- How and how many gaskets values ( Y and m) I have to consider in the calculation?
- How is the sealing between the two halves if there is no gasket in the middle ( case 1) ?
- Do I have to consider as gasket "G" either the G of the Spiral Wound and the G of the Omega gasket which could be at the weld??
THANK YOU FOR YOUR TIME !!
Kind regards
mombu
has anybody already experienced the calculation and use of this kind of gaskets ?
I am facing the calculation of carrier ring gasket with OMEGA RING in two(2) halves with two cases "on the table":
CASE 1) two 2 halves of OMEGA metal gasket each holding a spiral wound gasket which are in contact with the flange face.
CASE 2) two 2 halves of OMEGA metal gasket each holding a spiral wound gasket which are in contact with the flange face + an additional spiral wound gasket in the middle and between the two halves.
- How can I perform the calculation?
- How and how many gaskets values ( Y and m) I have to consider in the calculation?
- How is the sealing between the two halves if there is no gasket in the middle ( case 1) ?
- Do I have to consider as gasket "G" either the G of the Spiral Wound and the G of the Omega gasket which could be at the weld??
THANK YOU FOR YOUR TIME !!
Kind regards
mombu
