MohammadAtteya
Mechanical
When trying running CATIA V5 R17 a "Click Ok to terminate" message appears, is that because my machine has DDR1 RAM?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
CATIA 17 problem setup
- Thread starter MohammadAtteya
- Start date
- Status
tuzoenduro
Automotive
Ignore JuhaEdag's comment, CATIA can break off and stop for a whole number of reasons, legal copy or not.
If it does this very often verify that your computer setup is up to code and everything you have is properly certified by Dassault. You can check on their site for you grafic card and memory and whatnot.
Other than that, it can be a problem of need of memory, a problem with your pieces, between other reasons.
If all else fails, call Dassault's assistance, or your local reseller.
If it does this very often verify that your computer setup is up to code and everything you have is properly certified by Dassault. You can check on their site for you grafic card and memory and whatnot.
Other than that, it can be a problem of need of memory, a problem with your pieces, between other reasons.
If all else fails, call Dassault's assistance, or your local reseller.
- Thread starter
- #4
- Status
