beaerohead2
Aerospace
In CATIA V5 how do you project curves for a dwg to a plane in space. I used to know how to do it but have been using UG an forgot??
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
catia project curves for a dwg to a plane in space.
- Thread starter beaerohead2
- Start date
- Status
Welcome to V5, DRW2SPC does not exist anymore...
But as you might have notice, the tools available in a Drawing view are very similar to the one from the sketch workbench...
Copy the View from the tree and paste it in 3D, this will give you a sketch!
Sorry I do not know nothing about UG(LY)...
But as you might have notice, the tools available in a Drawing view are very similar to the one from the sketch workbench...
Copy the View from the tree and paste it in 3D, this will give you a sketch!
Sorry I do not know nothing about UG(LY)...
Eric N.
indocti discant et ament meminisse periti
indocti discant et ament meminisse periti
- Thread starter
- #3
- Status
Similar threads
- Question
- Locked
- Question
- Question