CATIA V5 R19_Creation of 3D Point

[dz78]

Good day to everybody,

Using Part Design of Generative Surface Design:
Please, anybody know which command and procedure I have to follow in order to create a 3D point made from the intersection of 3 planes?

Kind Regards,
Diego

 

[jackk]

There is no CATIA command that will intersect 3 planes. But you can do it in two steps

To get the point where 3 planes intersect, first use the Intersection command to intersect two of the planes and then intersect the resulting line with the third plane.

 

[itsmyjob]

isolated point coincident with each plane is another solution

Eric N.
indocti discant et ament meminisse periti ​