Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Center Line Modification Points

Thread starter TheRealDeal55
Start date Jan 7, 2020

Status: Not open for further replies.

Jan 7, 2020

TheRealDeal55

Automotive

My Catia software was recently updated to R28. I noticed that when I create any center line in drafting I am unable to modify it by elongation. Previously there were dot toggles on the ends to elongate in one desired.
When I double click the center line the dots on center line does not appear. Is there a remedy to this?Any help would be appreciated.
Thanks,
Curt