Centerlines in Drafting views???

[3dr]

I'm trying to find how to control display of centerlines in drafting views and I'm totally lost. I used to know how this was done! Frustrating.... can some body point me in the right direction?

TIA

Dave

 

[looslib]

Utility Symbols


"Wildfires are dangerous, hard to control, and economically catastrophic."
"Fixed in the next release" should replace "Product First" as the PTC slogan.

Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand

 

[3dr]

Yes.... that seems to be where they can be created
However what I'm looking for is how to control the automatic creation of them. That isn't done there is it? I'm sure I remember it being buried in prefrences somewhere.

TIA

Dave

 

[3dr]

How do I gain access to a "saved" WCS? If I save it I can't name it........... and I can't seem to reactivate it by clicking on the green phantom wcs it leaves behind in mdel space. The old stuff I used to use allowed you to name a coordinate system so you could jump back to later. What am I missing here? I'm sure NX can do this!

TIA again! LOL! Dave
NX3

 

[mmauldin]

There is a "Create Centerline" checkbox in the "Add View" dialogue box.

 

[3dr]

Excellent!!.... Thankyou!..... I knew it was somewhere right in front of me!

Dave