Changing CONFIG in workbench

[vidiii]

I get the following error in ANSYS Workbench when doing a flexible dynamics simulation:

*** ERROR *** CP = 2183.203 TIME= 22:50:21
Number of results on results file exceeds maximum of 1000.
Maximum may be increased with /CONFIG command.

I'm not using APDL (batch script), so is there a way to change that config in workbench?

Kindest regards, and thank you very much.

 

[vidiii]

Solved:
Insert command:
/CONFIG,NRES,1e6

 

[vidiii]

Actually it didnt work out, maybe because I get:
! Commands inserted into this file will be executed just prior to the Ansys SOLVE command.
! These commands may supercede command settings set by Workbench.

And it must be set in the beginning of the file.

Any ideas?

 

[vidiii]

Final solution:

FINISH
/CONFIG,NRES,1000000
/PREP7
/NRES,,999999