Changing / Linking multiple hole parameters together 1

[PBPouw]

I received from a customer a double contoured part with around 200 countersunk holes in them.

I am asked to change all holes to an other diameter and without countersunk.

Is there a way to link all these 200 holes to the same set of parameters?

Offcourse without linking every hole separately !

 

[itsmyjob]

not really linked but KWE can change all Hole dimension with one rule

[b]H.Hole[/b]

if H.Diameter <> 5mm then H.Diameter = 5mm

again another rule can change the type

if H.HoleType <> "Simple" then   H.HoleType =  "Simple"

That will affect all Hole feature in part.

2 minute job with KWE license

Eric N.
indocti discant et ament meminisse periti ​

 

[jackk]

2 minutes? You must be a slow typer Eric

but a good tip!

 

[PBPouw]

I think I have to do a DIY KWE course when the work pressure is lower !

Can you give me a short course ? and or a bit more which exact function I have to use, this because I tried and failed..............

 

[ferdo]

Same thing can be done also in script

Regards
Fernando

https://picasaweb.google.com/102257836106335725208

https://picasaweb.google.com/103462806772634246699/