Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Changing the coordinate system

Thread starter meher634
Start date Feb 26, 2004

Status: Not open for further replies.

Feb 26, 2004

meher634

Mechanical

I would like to know if theres any option where we can change the coordinate system, eventhough the model is created at the origin in the cad modeller,mini-axis doesnt show the model at the origin,is mini axis the reference coordinate system in algor??
Thank you all