Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Changing the Render 'ground plane' in CATIA V5

Thread starter hamzstar13
Start date Jan 1, 2011

Status: Not open for further replies.

Jan 1, 2011

hamzstar13

Computer

Is there a way in CATIA V5 to change the plane that the ground is parallel to...
i.e. I have designed a car in CATIA but while rendering the ground will only be located to the side of the car rather than under the wheels.

Any tips would be appreciated

Thanks in advance