Feb 13, 2003 #1 VINN Mechanical Feb 13, 2003 13 CA HI, I CAN CHANGE UNITS FROM ISO TO ANSI IN DRAWINGS BUT NO IN PART MODELS. WHEN IM CREATING GEOMETRY ITS ALWAYS IN METRIC. WHERE CAN I CHANGE STANDARD SO ITS ALWAYS ANSI IN EVERY TYPE OF MODEL UPON START UP. THANK YOU IN ADVANCED. VINNY
HI, I CAN CHANGE UNITS FROM ISO TO ANSI IN DRAWINGS BUT NO IN PART MODELS. WHEN IM CREATING GEOMETRY ITS ALWAYS IN METRIC. WHERE CAN I CHANGE STANDARD SO ITS ALWAYS ANSI IN EVERY TYPE OF MODEL UPON START UP. THANK YOU IN ADVANCED. VINNY
