Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IFRs on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Check and inform about chain of selected curves

Thread starter bcl001
Start date Aug 29, 2012

Status: Not open for further replies.

Aug 29, 2012

bcl001

Industrial

Hi everyone, I am looking for functionality about checking a selection of curves on chainability.
This means by box-select [or group] and then run any automation to check the involved curves on "chainability". This could be >1000 elements.

I want to use it on dxf geometry, before WireEDM machining and some other applications.

Kind Regards, Bert