Cladding of Al-alloys with Ni-based alloys

[bagnamento]

Hi everybody;
has anyone experienced cladding of Al-alloys sheets with Ni-based alloys (Inconel)?
In case it was possible, which cladding method would be better?
I guess it should be done by roll cladding.

 

[Goahead]

Explosion welding of aluminum/stainless is reported, so probably also aluminum/nickel-base would be feasible.
Roll welding of aluminum to stainless is reported difficult but possible, same as aluminum to nickel.

http://www.welding-advisers.com/

 

[bmoorthy]

You may want to check wit JSW.

If the bottom of Aluminium is plated prior to roll bonding the problems nay be reduced.

 

[EdStainless]

There is a lot of stainless/AL bond experience from the cookware industry.

= = = = = = = = = = = = = = = = = = = =
Corrosion, every where, all the time.
Manage it or it will manage you.

http://www.trent-tube.com/contact/Tech_Assist.cfm