Anyone know some good relatively cheap software to communicate with Fanuc or Mazatrol controls. All I want to do is read and punch programs instead of keying in at controls.
I know I can write prorams with wordpad or notepad which is what I use alot. But how do I send or recieve the program.
I was hoping t use a RS 232 connection.
I have had success with Predator DNC software in the past, not sure how much $$$ it is now, probably not too bad. They offer many packages depending on your needs, send them a request for info, it can't hurt.
go to programs, accessories, communications and you will see hyperterminal. If you need set up info for fanuc let me know. Basically you just have to set up the baud rate and comm's just like anything you would use rs232 to do on fanuc.