I have to connect together two air dielectric coaxial cables with same external diameter, but different diameter of the inner conductors.<br>My question is: how can I simulate this kind of connection?<br>I have a microwave CAD but unfortunatly the program doesn't work on this kind of component (I think is possible simulate it with a capacity, but I don't know how to relate the capacity to the geometrical dimension of the lines).<br>Could someone help me?<br>Thank you.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Coaxial cables impedance matching
- Thread starter antennas
- Start date
re0621re0621
Electrical
Hi
Try using ANSOFT HFSS Which can handle all these kind of problems.
Try using ANSOFT HFSS Which can handle all these kind of problems.
modematcher
Electrical
Dear antenna
I think it is more useful to solve this problem analytically & use CAD's software for complicated problems so you can simulate 2 coax. line that can guide TE & TM mode in addition to TEM modes & then marginal conditions ...
If you want more information do not hestitate
I think it is more useful to solve this problem analytically & use CAD's software for complicated problems so you can simulate 2 coax. line that can guide TE & TM mode in addition to TEM modes & then marginal conditions ...
If you want more information do not hestitate
- Status
Similar threads