Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

command line error in calculations

Status
Not open for further replies.
agodave

agodave

Industrial
Dec 8, 2006
4
If I'm working in an inch drawing and need to convert to metric to do an offset or drawing. When I do this the system rounds off and does not calulate to a high precision. Do anyone have any ideas where to change this if possible. for example 2.73/25.4 = .1074803 in draftsight I get .1092 or an erro rof .00172 inches.

Any ideas

Dave


 
Status
Not open for further replies.

Similar threads

BarryCole
  • Locked
  • Question
Line colours
Replies
0
Views
362
BarryCole
BarryCole
PLCAlligator
  • Locked
  • Question
Unable to Import a PDF into a DWG/DXF File in Draftsight 2020 Enterprise
Replies
0
Views
580
PLCAlligator
PLCAlligator
MechEngLR
  • Locked
  • Question
Angle Line Command
Replies
0
Views
125
MechEngLR
MechEngLR
Lstern
  • Locked
  • Question
Trimming seems bugged in 2022 Draftsight
Replies
0
Views
379
Lstern
Lstern
parsakaali
  • Locked
  • Question
_FROM command modifier no longer working
Replies
2
Views
88
parsakaali
parsakaali

Part and Inventory Search

Sponsor

Back
Top Bottom