Can someone helps me to find/tell me where is the right procedure for the materiel selection in the ASME BPVC Section VIII of a compressed air receiver 400 litres/40 bar.
7mayda, I don't have expertise in the subject, but usually from consideration of the process, desired life of the equipment, experience with similar services, and so on.
Regards,
Mike
The problem with sloppy work is that the supply FAR EXCEEDS the demand
See UG-16 (b)(4) the minimum thickness of shells and heads used in compressed air service, steam service, and water service,
made from materials listed in Table UCS-23, shall be 3/32 in. (2.5 mm) exclusive of any corrosion allowance.
Regards
r6155
Forged 3000 lb. For ngs and schedule 80 seamless pipe. Forged 2000 lbs. Valves made it of steel. Valves made in the usa by Contract or Sharpe valves. Threaded or flanged.