DrBwts
Mechanical
- Nov 4, 2012
- 297
I have an Assemble that is pretty much the repetition of sliders & cranks. The only difference between sliders is their diameter & the only difference between cranks is the angular offset.
Yet given all the sliders were constructed in exactly the same manner and have exactly the same mates. I can not get the last slider to mate concentrically with the main axis. I'm only using this mate for positioning & all the other comonents did not have a problem. I can manually align it but I cant do it automatically as it complains that the centres are too far away from each other.
What I have tried:
Deleted all the mates & started again... no luck.
Deleted the part and rebuilt it from scratch.... no luck
Rebuilt the whole assembly.... no luck
Anyone else had this issue before?
Yet given all the sliders were constructed in exactly the same manner and have exactly the same mates. I can not get the last slider to mate concentrically with the main axis. I'm only using this mate for positioning & all the other comonents did not have a problem. I can manually align it but I cant do it automatically as it complains that the centres are too far away from each other.
What I have tried:
Deleted all the mates & started again... no luck.
Deleted the part and rebuilt it from scratch.... no luck
Rebuilt the whole assembly.... no luck

Anyone else had this issue before?