Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

contact between an analytical rigid part and a wire beam

Status
Not open for further replies.
am69sh

am69sh

Mechanical
Nov 12, 2014
2
Dear all
I'm trying to simulate a rotating cylinder-piston which has telescoping motion too. The cylinder is analytical rigid and the piston is a deformable wire beam (3D). the error is: "NO COUPLING NODES WERE FOUND.IT MAY BE NECESSARY TO INCREASE THE INFLUENCE RADIUS"
Please Help!
 
Status
Not open for further replies.

Similar threads

Kamyar_K
  • Locked
  • Question
Contact Interaction and Gravity
Replies
3
Views
1K
FEA way
FEA way
E
  • Question
CONTACT IN MERGED PARTS
Replies
7
Views
5K
EbrahimGamaleldin
E
mj345
  • Question
contact generation
Replies
2
Views
2K
mj345
mj345
liq001
  • Locked
  • Question
switch rigid body on and off between steps
Replies
16
Views
317
liq001
liq001
Z
  • Question
Trying to simulate friction contact of two parts
Replies
13
Views
6K
zhuang joe
Z

Part and Inventory Search

Sponsor

Back
Top Bottom