Contour Flange Profile Problem

[oneilldm]

I'm creating some Derived Parts. I have a master sketch in the first part for a set of related parts.

Some of my profile lines will not select properly. These are really simple parts. For example, I have 2 adjacent lines shaped like an "L". When I go to select it as the Profile for my Contour Flange it will only select one line (or the other). I've tried all the obvious things.

Any ideas? (I'm using v7)

Thanks

 

[sg20]

How about right-click on the sketch in the tree manager, command shared sketch.

 

[Ratso]

Or use project geometry...????

 

[oneilldm]

Well I got it to work. I went in and sketched a line beyond the intersection, extended my 2 adjacent lines then trimmed them back to the intersection again. That seemed to do the trick, but surely there is a better way.