Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Convert v7 to v8 with a .csv file??

Status
Not open for further replies.

dhowser

Civil/Environmental
Jan 17, 2005
2
US
Has anyone successfully converted a v7 dgn file to a v8 file using a .csv file? I have tried exporting the latest level setup from a seed file I created with still no luck. Any Suggestion??
 
Replies continue below

Recommended for you

I gave up as well. I found it is easier to just to use selection sets and change symbology. It's the longer way but the safe way. If you use InRoads for planametric mapping, you can try to change your DTM to a feature based model then display it as mapping.
 
Thanks for the help. I ended up creating a macro that imports the leveling scheme that I want into the old drawings. Thanks again.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top