Converting splines into arcs and curves

[DieMan44]

thread561-168453

Is there a method to convert splines into arcs and curves. In MasterCam there is a convert command but I can find no such command in UG.

UG NX 5.0.4.1

 

[uwam2ie]

insert>curves from curves-> simplfy (curve)

 

[DieMan44]

Excelent!! Thanks so much! Now they just need to add a feature that would allow a user to select with a window instead of one spline at a time. I have several hundred I need to convert, but at least I can convert them.