Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Conveyors automation

Status
Not open for further replies.
Beta101

Beta101

Electrical
Jan 21, 2006
11
Hi,

I currently investigating automating a 3km conveyor for coal overseas. The project will be designed in Australia. I am keen to find out the appropriate safety standards AS61508, AS61511, AS4024 etc...that I need to use and why. As I am new to these standards i would appreciate any guidance.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
If its installed overseas I'd expect the overseas standards to be more applicable, though if its to be installed in an IEC area, I believe that the standards you've referenced have an IEC equivalent which makes things somewhat easier.

However, should you be in Queensland there may be a few more onerous requirements regarding engineering approvals even though the project is destined for overseas, given that QLD is the only state that has a government sanctioned Board of Engineers.
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom