Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

COORDINATE DIMENSIONING

Status
Not open for further replies.
SPETE

SPETE

Mechanical
Mar 16, 2005
2
I need to have solid edge display xo, yo instead of just "0" for coordinate dimensioning. I can't find anything that does it automatic in the settings. Is this not possible?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
1. Click on your "0" dimension.

2. On the Ribbon Bar change the Dimension Type to "Blank"

3. In the Prefix Menu type X0 or Y0

 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

blitz97
  • Locked
  • Question
base coordinate symbol display
Replies
2
Views
372
blitz97
blitz97
Spaceballster
  • Locked
  • Question
Annoying dimensioning behavior in draft
Replies
2
Views
115
Spaceballster
Spaceballster
Sion12
  • Locked
  • Question
ST5- Add-Helix command and modify length of helix? Dimensioning possible?
Replies
0
Views
96
Sion12
Sion12
robinbir
  • Locked
  • Question
ST4 how to remove unknown coordinate system? 1
Replies
2
Views
216
robinbir
robinbir
telcom2011
  • Locked
  • Question
defining a coordinate system fixed to a body
Replies
1
Views
150
telcom2011
telcom2011

Part and Inventory Search

Sponsor

Back
Top Bottom