Copy and paste .dft used in assembly

[berndtsl]

I have multiple assemblies and parts used in set assemblies in 1 folder.
All parts and assemblies have a .dft.
If I want one of the assemblies (and all parts used in the assembly) copied into a new folder, I would use revision manager.

I would like to know how to copy and paste the corresponding .dfts without manually copy one-by-one.

 

[Kenny_G]

Select your entire structure in rev man and then select the Where Used and uncheck everything but Drafts. You can then copy/move those too.

Ken G.

http://grundey.blogspot.com

Have you checked out the Solid Edge Community site?

http://community.plm.automation.siemens.com/t5/Solid-Edge/ct-p/solid-edge

 

[berndtsl]

Thank You! Saved lots of time.