COSMOSXpress and simulation

[duddini]

Hi all, I hope someone can help me. I've done a keyword search and found nothing to help, so I'll try posting. I have an assembly that I would like to load in tension using COSMOSXpress, but it tells me I have to run a physical simulation. The options are motors and springs, not really what I'm looking for. Can I do this with Xpress or do I need the full-up COSMOSWorks ??

Thanks all,
Bob


"You can observe a lot just by watching"
Yogi Berra

 

[MadMango]

Xpress only works with parts, not assemblies.

[green]"Art without engineering is dreaming; Engineering without art is calculating."[/green]
Steven K. Roberts, Technomad
Have you read faq731-376 to make the best use of Eng-Tips Forums?

 

[duddini]

Thanks MadMango, you saved me alot of time dinking around trying to figure it out.
Looks like it's back to Roark & Young

Thanks again.

"You can observe a lot just by watching"
Yogi Berra