Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Crack

Thread starter Sri21
Start date Apr 5, 2014

Status: Not open for further replies.

Apr 5, 2014

Sri21

Mechanical

In Abaqus CAE when I am modeling my top surface of the crack doesn't bend with the bottom surface of the crack, it interpenetrates with each other how to fix it. I can put constraints between the surfaces but that doesn't give me the right results. I am modeling delamination in composite material.