Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Create a solid from a sheet 3

Status
Not open for further replies.
Replies continue below

Recommended for you

You can use THICKEN and make thickness in the menu the wall thickness of the tube.
If the wall goes the wrong way then flip it with the arrow.

Capture5_fgputo.jpg

Capture6_rsxdzz.jpg


Jerry J.
UGV5-NX1899
 
In order for a Sew operation to create an actual solid, the surfaces must completely enclose the volume of space. I other words, it must already be a 'watertight' network of surfaces before your perform the operation.

John R. Baker, P.E. (ret)
Irvine, CA
Siemens PLM:

The secret of life is not finding someone to live with
It's finding someone you can't live without
 
I got it.
Thank you, John R. Baker.

CAD 2015
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor