Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Create and propagate crack in epoxy

Status
Not open for further replies.

raeisif

Civil/Environmental
Joined
May 29, 2014
Messages
5
Location
CA
Hi everyone,
I'm new to Abaqus, and faced lots of problem during my modeling.
I have an epoxy which is brittle and under tensile stress there will be some cracks on its surface. how can I model this epoxy and crack propagation in abaqus?

Thank you
 
May be you can start by using an elasto-plastic material model to simulate the tensile behaviour of the epoxy. If its brittle, VCCT may be used for crack propagation.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top