Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Create centre line of formed hose

Status
Not open for further replies.

inchjohn

Automotive
Oct 26, 2008
13
Hi,

Can anyone help, i'm trying to create a centre line from an imported hose from another cad system, I need to measure the overall length of curved hose.

Does anybody know if this can be done & if so how?

Thanks
 
Replies continue below

Recommended for you

Try offsetting the surfaces of the hose to a value which is approx 0.1mm less than the radius of the hose. Now run an iso curve curve along each of the offset surfaces.
Measure the total length of the curves.
Not 100% accurate but probably good enough.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor