Create Chamfer On One Edge Only?

[TheeCircle]

Hi,

I am working through some training exercises and can not figure this one out. I want to create an Asymmetric Chamfer to one edge of my blade as shown the photo. When I chose my edge it selects the entire part. How do I select only 1 edge?


Using NX10.

Thanks in advance!

John

 

[cowski]

Photobucket is blocked at my work place so I can't see which edge you want to chamfer. However, I would guess that you need to check the selected "curve selection rule" after you start the chamfer command. Choose the "single curve" option; it sounds like it may be set to "body edges" which would select all the edges in the body.

www.nxjournaling.com

 

[TheeCircle]

Hi Cowski,

There is no "single curve" option? It only has edge at that point.

Thanks

John

 

[cowski]

The "curve rule" shows up in the selection toolbar, separate from the main command dialog.

www.nxjournaling.com

 

[TheeCircle]

Hi Cowski,

Many thanks!!!

John