Creating a sphere

[dwarf12]

Hallo all,

I'm a novice at ABAQUS 6.9 and have a little problem. I'm trying to create a sphere-model and it doesn't work.

I hope the problem not too easy for you...

It would be fine to get a response.

Thank You

 

[Fabi0]

What's the problem? I mean: when did u encounter problems?
About modeling the part or what else?

 

[dwarf12]

It's about modelling. I've creating a circle in the "sketch". The problem is to to get a sphere out of the circle when I want to creat the part

Than You

 

[rstupplebeen]

Create part> type: Revolution>
Create half a circle, connect the 2 free ends with a line. Should look like a "D". Accept the sketch revolve 360deg. I hope this helps.

Rob Stupplebeen

 

[dwarf12]

It works!

Thank you so much...

This was very helpfull for me.