Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

creating an output waveform from a data array

Thread starter stampyoldani
Start date May 28, 2008

Status: Not open for further replies.

May 28, 2008

stampyoldani

Mechanical

hello,
I am a labview beginner, I have an analog waveform that get created in the use of a lab device, I can capture this waveform as a CSV array of numbers. I then want to import this waveform into a labview VI that will drive an analog output on my DAQ. any tips greatly appreciated.