Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Creating mnf file with stress

Status
Not open for further replies.
jaroslavkorf

jaroslavkorf

Mechanical
Nov 24, 2011
1
Hi, I'm trying to create mnf file for ADAMS analysis, but created mnf file doesn't contain von Mises stress. ADAMS postprocessor shows message:

WARNING: There is no Von Mises Stress information for any of the bodies in the default view.
The contour plot legend visibility has been turned off.
 
Status
Not open for further replies.

Similar threads

M
  • Question
Using if expressions for creating law curves 1
Replies
7
Views
3K
MbToxic
M
Atharva_Mechanical
  • Locked
  • Question
Creating wire fencing using NX 2
Replies
7
Views
344
Atharva_Mechanical
Atharva_Mechanical
CAD2015
  • Locked
  • Question
NX - Creating a drawing from a part...... 2
Replies
6
Views
737
CAD2015
CAD2015
rafi22
  • Locked
  • Question
creating hotkeys /shortcut key for userdefined custom view
Replies
0
Views
1K
rafi22
rafi22
MANox
  • Question
Hole with fit
Replies
0
Views
1K
MANox
MANox

Part and Inventory Search

Sponsor

Back
Top Bottom