Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Creating PIST points

Status
Not open for further replies.

Hitchcock

Aerospace
Sep 3, 2007
3
Hello All,

I am trying to create standard vector-point sets and describe their location and direction relative to a chosen CSYS. The points are located on a face and the vector is normal to the face. I have tried using the coordinate note feature in PMI, but this seems only to give results in absolute. My current workaround involves many steps per point, and we create several hundred of these at a time. Does anyone have any advice on this?

Thanks,
Hitchcock
 
Replies continue below

Recommended for you

please contact me and describe what you will be using the point/vector data for and I may be able to point you down the right path.

Ashley Kerth-
akerth@6dms.net
503.803.3294

6dms, Inc.
506 SW 6th Ave., Suite 600
Portland, Oregon 97204
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor