creating reference curves

[raysapp]

When I want to create a reference dimension in a sketch, this is something I can determine before its created. However I can't figure out how to do this with a curve. I create a line and then convert to reference. Am I missing something?
Thanks

Ray S
NX 7.0.1.7

http://www.appliedprecisionproducts.com

 

[hudson888]

Select the line and then just hit the convert to reference icon.

Make sure also that the curve that you want to convert to reference is in fact not outside of the sketch.


Best Regards

Hudson

www.jamb.com.au

Nil Desperandum illegitimi non carborundum

 

[raysapp]

Thanks, but thats what I'm doing now. I just think it would be nice to have an option to toggle when I'm creating the curves. No big deal.

Ray S
NX 7.0.1.7

http://www.appliedprecisionproducts.com

 

[Crocostimpy]

Make sure the little radio button for Reference is selected. You can pick either Reference or Active. The system remembers what was selected last, so if you have changed a reference line back to active, you'll have to reselect the Reference button.

IMO it should just be a toggle, and just change the line to the opposite of what it is. It would be easier that way.

Mike