Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Creating Threads?

Status
Not open for further replies.
a0r0t

a0r0t

Mechanical
Oct 27, 2002
28
How do you create real type threads (not cosmetic) on a piece part?

I'm new to SW so please be specific.

Thanks!

-Art

SW 2004
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Do a search in this forum. There are A LOT of threads about this subject. For short, draw the thds in a sketch, then revolve.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

lgchan
  • Locked
  • Question
Creating Dimension on Sketch then Extrude
Replies
0
Views
103
lgchan
lgchan
LeRepeteur
  • Locked
  • Question
Creating a Sketch from Sheet Metal Design to create a Part Profile
Replies
3
Views
204
ctopher
ctopher
FranscoisMH
  • Locked
  • Question
Solidworks Automation: Creating a flat pattern drawing from a sheet-metal part with automatic dims
Replies
1
Views
231
SBaugh
SBaugh
toycept
  • Locked
  • Question
Creating DXF file with various depth cuts
Replies
7
Views
309
Jboggs
Jboggs
CheckerHater
  • Locked
  • Question
Incomplete Threads 3
Replies
11
Views
346
SBaugh
SBaugh

Part and Inventory Search

Sponsor

Back
Top Bottom